Technical information

V4 Logger User Guide 66

Setup for the DIO – 24 H card and iMediaLogger

The DIO – 24H card requires 3 – 2.2K 9 Pin SIPS (Pull up resistors) and a

5 volt DC power source if using output closures to drive relays or logic

circuits. The software for the DIO card is the InstaCal software and is

available for direct download at:

http://www.measurementcomputing.com/download.htm

You can install the DIO card prior to installing the InstaCal software and

simply cancel the Windows installer when it appears after reboot. To

install the InstaCal software:

Download the “InstaCal” software by selecting clicking on the

above link. You can click on the highlighted link from the

download section shown in the screen shot below.

You will see this screen after clicking on the “InstaCal” link.