Technical information

V4 Logger37

V4 Logger

Configuration - Continued:

Archives

The archives section will allow the user to send scheduled recorded audio based on feed to a specific

ftp location. This will also allow the user to configure there WebSecure+ ftp account based on IP

address.

Select “Add” to proceed and you will see the screen below.

Create any desired name for the ftp site or leave as the default naming convention. The host name

can be DNS based or IP address. If you are using an DNS name or IP address, no UNC naming

convention (\\) is required. Port 21 is the standard ftp port and this can be set to any desired value.

Username and password for the WebSecure+ unit is mts and 1234 by default. The “Path” would be

left blank if you are configuring for WebSecure+ and the user can set any folder path desired for

custom ftp sites. Enable the “This is a WebSecure Upload” to transfer audio to the WebSecure+

appliance and leave unchecked if this is a standard ftp site.