Technical information

V4 Logger29

V4 Logger

Configuration - Continued:

Server Settings

This will display the version of the Logger software and allow the user to change the name that will be

displayed on the Server Identity displayed in the built HTML page in Logger.

Event Logging

The General Status is the only item that is enabled by default in the Logger application. However, it is

strongly recommended that the user enable all event logging to assist in schedule tracking, closure

and audio validation, and potential troubleshooting.

General Status - Displays completed events

Feed Related - Displays Feed names associated with start, stop of recordings

Network Related - Displays the IP address of any computer accessing the HTML

Interface

Serious Error - Displays failed recordings, error codes, audio device failures,

etc.

Schedule Related - Displays schedule failures based on conflicts, incomplete

recordings, etc.

The file path is the location of where the Logger event log will be created and updated. This location

can be changed form the default to suit the user requirements.

Maintenance

The Enable File Cleanup is active and set to 30 days based on Canadian CRTC requirements. This

value is known as the “Global” file cleanup setting and the value can be increased to 999 days or

decreased to a minimum of 1 day.

NOTE:

Be sure to check the amount of storage on your secondary or storage array as increasing the Global

file cleanup settings past 30 days can require a significant amount of hard drive space depending on

the local recorded format. There could be a danger of filling up your hard drive causing the Logger

application to hang or fail.