Technical information

V4 Logger27

V4 Logger

Configuration - Continued:

Destinations

OMT recommends that all workstations running our software contain a separate OS and storage hard

drive. This will dramatically improve performance as the OS drive is not trying to write or access the

disk when write audio files to a specified storage location. With two drives one is always dedicated to

the operating system while the storage drive is always recording digital files on to the storage drive.

This location is referenced during the setup installation of Logger. However, additional locations can

be added by selecting the “Add” button. “Edit” will allow the recording location to be changed after the

initial setup and configuration. “Remove” will remove the default destination entry.

Selecting “Add” brings up the following screen.

The title can be changed to any suitable name while the location can be selected by clicking on the

“Browse” button. “New Destination 1” is the default Title and this can be changed to any suitable

name that the user desires.

Highlight on a destination in your list then select “Edit” and you will see the following screen.

Browse to a suitable storage location and click on “OK” when complete.

NOTE:

USB drives are not recommended by OMT as an additional storage location based on their slower

read/write times in comparison to an EIDE or SATA II internal hard drive. Some clients have had

success using USB drives and we leave this to the discretion of the Logger user.