Technical information

V4 Logger User Guide 132

Once you have select “PCIFIND” the screen on the right will appear. You should see a

valid IRQ and base address with no error messages.

Reboot the computer and “Allow Windows to Install Software Automatically” upon

detection of the Kontron WDT 500 card when the computer returns to the Desktop. Your

card should now be ready for use. You can also go to the Device Manager in Windows to

verify the card is installed properly.

Setup for Logger:

Follow the same software installation procedures as outlined earlier in this guide and

when complete, launch the Logger program and select “Tools” from the top left corner of

the main screen.

Then select “Configure”.