Technical information

V4 Logger129
© 2010 OMT Technologies
Use several cable ties to bundle wires neatly and allowing for maximum air flow inside
your computer chassis.
Special Notes:
The lead supplied by Kontron on the WDT 500 card will come with either a red or black
control wire pre attached on the “WDRST” terminal. The “After” shot below was taken
from a second computer that required a WDT 500 card.
Before After
The reset wire that comes pre-attached will be connected to the WDRST lug. The
/WDRST would provide an inverse condition if additional logic is required to flag or
control other devices.
You are now ready for the software installation. Upon starting the computer, you will
see a “Found New Hardware” where you can cancel and install the Kontron software from
CD or Website first.