Technical information

V4 Logger125
© 2010 OMT Technologies
HARDWARE INSTALLATION
Power down the computer you wish to install the card into and remove the cover. Install
the PCI WDT 500 card into a suitable PCI slot and ensure the card is seated and free of
wire or cable obstruction. Find the following power supply wire as per the outline from
the PCI WDT 500 guide.
The ATX pin out will be the same on the current 24 pin power connectors with exception
of four additional wires. The “Grey” wire should still be in the same location at Pin 8.
The diagram to the right is for older AT type power supplies used with early Pentium
series computers.
Special Notes:
Prior to installing your PCI WDT 500 card, ensure your computer has a sufficient number
of PCI based slots as most newer computer manufacturers only supply 2 PCI 2.0 type
slots on the motherboard of a workstation class PC. If you have an audio card, closure
card, and the watchdog card you will be short a PCI device.