User manual

Index
© National Instruments Corporation I -2 PC-DIO-96/PnP User Manual
A
ACK* signal
description (table), 3-13
mode 1 output timing (figure), 3-15
mode 2 bidirectional timing (figure), 3-16
AIRQ0 bit, D-9
AIRQ1 bit, D-9
APA<7..0> signal (table), 3-3
APB<7..0> signal (table), 3-3
APC<7..0> signal (table), 3-3
B
base I/O address settings
PC-DIO-96, E-4 to E-8
example settings (figure), E-6
factory settings (figure), E-4
switch settings and corresponding
address ranges (table), E-7 to E-8
verifying usage by other equipment
(note), E-5
PC-DIO-96/PnP, 2-3
programming considerations (note), D-1
BIRQ0, D-9
BIRQ1 bit, D-8
bits
AIRQ0, D-9
AIRQ1, D-9
BIRQ0, D-9
BIRQ1 bit, D-8
CIRQ0, D-8, D-35
CIRQ1, D-8
CTR1, D-10
CTRIRQ, D-10
DIRQ0, D-8
DIRQ1, D-8
IBFA, D-15, D-22
IBFB, D-16
INTE1, D-22, D-35
INTE2, D-22, D-35
INTEA, D-15, D-18, D-35
INTEB, D-16, D-18, D-35
INTEN, D-10, D-35
INTRA, D-15, D-18, D-22
INTRB, D-16, D-18
I/O, D-15, D-18, D-22
OBFA*, D-18, D-22
OBFB*, D-18
block diagram
PC-DIO-96, E-2
PC-DIO-96/PnP, 4-1
board configuration. See configuration.
BPA<7..0> signal (table), 3-3
BPB<7..0> signal (table), 3-3
BPC<7..0> signal (table), 3-3
bulletin board support, F-1
C
cable assembly connectors, 3-4 to 3-6
pins 1-50 (figure), 3-5
pins 51-100 (figure), 3-6
cabling for PC-DIO-96/PnP, 1-5 to 1-7
CIRQ0 bit
description, D-8
interrupt handling, D-35
CIRQ1 bit, D-8
configuration. See also signal connections.
PC-DIO-96, E-3 to E-9
base I/O address settings, E-4 to E-8
example settings (figure), E-6
programming considerations
(note), D-1
switch settings and
corresponding address ranges
(table), E-7 to E-8
verifying usage by other
equipment (note), E-5
block diagram, E-2
factory-set switch and jumper
settings (table), E-4
interrupt level selection, E-8 to E-9
IRQ5 default setting
(figure), E-9
parts locator diagram, E-3