Owner's Manual

Part # RVCLPMB
Programmable Back Up Camera
Camera Angle Adjustment Screws
Install with Up arrow on top
Cut white wire loop to
disable backup guide lines
Video Cables
(Monitor to Camera)
Power Cord
Backup Guide-Line Programming
Unit normally has On-Screen display of backup Guide-Lines to assist you in backing up.
If you wish you may cut the thin white wire loop to turn off this feature.
Power cable
Atttach to the power and ground of the white backup light in your car
(the white light that comes on when you set your car to reverse)
Red wire goes to + Positive of the light and Black goes to - Negative of the light
Video Cable
A video cable is provided to to send the video immage to your car dash monitor
An extra red wire is provived to help you to get the backup light + power to treigger your LCD monitor.
( If needed then attach the thin red wire from RCA cable to the red + power wire from backup light and
attach the other end to your monitors + trigger wire )
Camera Mount Position
Please install the camera with the UP ARROW showing to the sky
(so image will not be upside down)
Camera angle can be adjusted after loosening the top 2 Philips set screws
(remember to re-tighten the 2 screws after angle adjustment )