System information

86
APPENDIX A — PIC 5 SCREEN AND TABLE STRUCTURE (cont)
ISM Status
ISM History
LEGEND *Default value is shown only if configurable in this table.
CCN TABLE NAME: MAIISMC
PIC 5 PATH: Main Menu  Maintenance Menu ISM Status
LINE PIC 5 DESCRIPTION CCN NAME RANGE
DEFAULT
VALUE*
UNIT READ/WRITE
1 Single Cycle Dropout cycle_1 NO/YES RO
2 Phase Loss ph_loss NO/YES RO
3 Over Voltage ov_volt NO/YES RO
4 Under Voltage un_volt NO/YES RO
5 Current Imbalance amp_unb NO/YES RO
6 Voltage Imbalance volt_unb NO/YES RO
7 Overload Trip overload NO/YES RO
8 Locked Rotor Trip lratrip NO/YES RO
9 Starter LRA Trip slratrip NO/YES RO
10 Ground Fault grnd_flt NO/YES RO
11 Phase Reversal ph_rev NO/YES RO
12 Frequency Out of Range freqflt NO/YES RO
13 ISM Power On Reset ism_por NO/YES RO
14 Phase 1 Fault phase_1 NO/YES RO
15 Phase 2 Fault phase_2 NO/YES RO
16 Phase 3 Fault phase_3 NO/YES RO
17 1CR Start Complete start_ok NO/YES RO
18 1M Start/Run Fault 1m_flt NO/YES RO
19 2M Start/Run Fault 2m_flt NO/YES RO
20 Pressure Trip Contact prs_trip NO/YES RO
21 Starter Fault strt_flt NO/YES RO
22 Motor Amps Not Sensed no_amps NO/YES RO
23 Starter Accel Fault accelflt NO/YES RO
24 High Motor Amps highamps NO/YES RO
25 1CR Stop Complete stop_ok NO/YES RO
26 1M/2M Stop Fault 1m2mstop NO/YES RO
27 Motor Amps When Stopped ampstop NO/YES RO
28 Hardware Failure hardware NO/YES RO
29 Calibration Factor Error calfc_er NO/YES RO
30 Invalid Configuration conf_err NO/YES RO
31 Unused un_used NO/YES RO
CCN TABLE NAME: MAIISMH
PIC 5 PATH: Main Menu  Maintenance Menu ISM History
LINE PIC 5 DESCRIPTION CCN NAME RANGE
DEFAULT
VALUE*
UNIT READ/WRITE
1 Line Current Phase 1 AMPS_H1 amp RO
2 Line Current Phase 2 AMPS_H2 amp RO
3 Line Current Phase 3 AMPS_H3 amp RO
4 Line Frequency FREQ_H Hz RO
5 Ground Fault Phase 3 GRFT_H1 amp RO
6 Ground Fault Phase 2 GRFT_H2 amp RO
7 Ground Fault Phase 1 GRFT_H3 amp RO
8 Phase 1 Faulted phase_h1 NO/YES RO
9 Phase 2 Faulted phase_h2 NO/YES RO
10 Phase 3 Faulted phase_h3 NO/YES RO
11 12T Sum Heat Phase 1 sum1ht_h % RO
12 12T Sum Heat Phase 2 sum2ht_h % RO
13 12T Sum Heat Phase 3 sum3ht_h % RO
14 Line Voltage Phase 1 VOLT_H1 V RO
15 Line Voltage Phase 2 VOLT_H2 V RO
16 Line Voltage Phase 3 VOLT_H3 V RO
RO — Read Only
RW — Read/Write