System information

19
Main Menu Screen
— To access the Main Menu screen, press
the Main Menu icon . Press the icons on the screen to access
the appropriate table or menu. Press the arrows at the bottom
right corner, if present, to navigate through pages of tables. The
options shown on the Main Menu screen depend on the user’s
level of access (see the section “User Login Screen”). Figure
21 shows the Main Menu screen as it appears for the User level
of access.
Configuration Screen
— To access the Configuration menu,
press the Configuration icon on page 2 of the Main Menu
(User, Service, or Factory access level). The Configuration
menu opens. Then press the General Configuration icon
on the Configuration menu. Press the arrows at the bottom
right corner to navigate through pages. See Fig. 22. (Certain
configuration settings are available only for Service or Factory
access levels.) Refer to Appendix A, page 67 for more infor-
mation about Configuration options.
To force a point, press the forcible point on the screen. Figure
23 shows an example.
The Force Variable screen opens, where you can select the
forced value. (Press the the Auto icon to cancel a forced point.)
See Fig. 24.
1
2
3
4
5
User Login Screen
Fig. 20 — User Login Screen
LEGEND
1—Arrows indicate active language
2—Measurement system (Metric or US Imperial)
3—Enter password
4—Login
5—Log off
a19-2145
Main Menu
Fig. 21 — Main Menu Screen (Basic Access)
a19-2146
CANCEL
MESSAGE
PREVIOUS
PAG E
NEXT
PAG E
SAVE
GEN_CONF - General Configuration
Fig. 22 — General Configuration Screen
FORCIBLE
POINT
GENUNIT - General Parameters
Fig. 23 — Forcible Point
NOTE: Special pressure vessels are required for Heating mode
(future option). Do not select Heating mode unless this option has
been purchased.
a19-2147
FORCED
VALUE
FORCED
AUTO
HC_SEL Force Variable
Fig. 24 — Forced Variable Screen
a19-2149