User`s manual

AEC-6897/6897LP Manual
21
Figure 3-32
3.5 SetBoot
If you have set more than one disk arrays, SetBoot lets you choose from which one
to boot. Suppose you want to boot from AEC-6897 on which you have installed OS,
you can move the highlight bar to “SetBoot”, press <Enter> and set as figure 3-33
shows. If there are two AEC-6897s, the final setting is the effective one.
WARNING !
Do not remove a Disk Array unless you are 100% sure that the data in that
array has been successfully backed up or the data is no longer needed.
Figure 3-33