User`s manual

AEC-6897/6897LP Manual
19
Upon booting, the BIOS of AEC-6897 will inspect the related information of hard
drives. If there is an array error, the screen will display the following two modes for
choice: (1) Take it into degrade mode; (2) Stopping it.
(1) Take it into degrade mode means that you can set spare to rebuild the array. (2)
Stopping it means that you cannot rebuild the array. If you are not sure whether the
newly replaced hard drive contains the data you need or not, please shoose (2) to
enter OS, and then decide if to rebuild or not.
Figure 3-26
If you choose (1) Take it into degrade mode, the array status will be in yellow as
figure 3-27 shows.
Figure 3-27
When you want to set a spare hard drive to rebuild the array, you can choose it by
moving the highlihgt bar and press the space bar to mark as figure 3-28 shows. An
asterisk (*) will appear before the chosen hard drive. Press <Enter> to save your
setting, or press <Esc> to cancel.