User`s manual

AEC-6897/6897LP Manual

Then, the system will ask if the following information is correct. Please press <Y> to

confirm as figure 3-6 shows.

Figure 3-6

3.1.2 RAID 1

RAID 1 is mirroring mode with fault tolerance. Data are written into two hard drives

at the same time, but one of the hard drives is used as backup, therefore the total

capacity is only one hard drive’s capacity. It is recommended to use two hard drives

of the same size.

First, move the highlight bar to “Create”, and choose RAID 1 from the pull-down

menu by pressing <Enter> as figure 3-7 shows.

Figure 3-7

The system will ask if you want to create an all new RAID 1 or a mirror for the

existing hard drive. Suppose to create an all new RAID 1 as figure 3-8 shows.

Figure 3-8