User`s manual

AEC-6897/6897LP Manual
11
3.1 Create Disk Array
3.1.1 RAID 0
RAID 0 is striping mode. It needs two hard drives at least, and accelerates the read/
write speed, but hasn’t any fault tolerance. First, move the highlight bar to “Create”,
and choose RAID 0 from the pull-down menu by pressing <Enter> as figure 3-3
shows.
Figure 3-3
Second, determine the hard drives’ block size. 128K is recommended to get opti-
mum performance under most circumstances.
Figure 3-4
Third, choose the needed hard drives by moving the highlight bar and press the
space bar to mark as figure 3-5 shows. An asterisk (*) will appear before the chosen
hard drive.
Figure 3-5