User`s manual

ACARD AEC-6280M
6
Chapter 2 Hardware Installation
2.1 Installation
The optimized default setting of ACARD AEC-6280M will meet your
demand without any modification in most cases.
Notice: system must meet the following items to work under UDMA66 data
transferring mode:
1. Make sure your IDE cable is for Ultra ATA66 HDD (40 pins; 80wires)
2. The hard disk supports Ultra DMA33 or higher transferring mode.
3. The PCI bus frequency is 33 MHz.
2.2 Hardware installation Procedure:
1. Open the Mac’s case. (Please reference the Mac’s manual.)
2. Choose an empty PCI slot and plug the AEC-6280M adapter.
3. Fix hard drive in your Mac.
4. Connect ATA-133 cable from adapter to hard drive.
5. Close the Mac case.
■ Connect 2 hard drives in the same channel, check the Master /
Slave jumper.
■ For the hard drive’s Jumper setting (Master / Slave), refer to
hard drive’s Manual.
■ As hard drive contain old data which might cause the Mac OS
installation problems. Before installing Mac OS, the hard drive
must be processed the “initialize” first.