User`s manual

12-03. Adv Setup

Read Error Skip

Press ENT to enter the following figure. The default is Off. Press ▼ to select On.

Read Error Skip

Off

5.1.4 Format HDD

Now press ESC and ▼ to enter the following figure. Format HDD is to partition the hard disk. But

before formatting, all data on the hard disk will be deleted.

12-04. Adv Setup

Format HDD

If your copy controller doesn’t connect with a hard disk, LCD will show the message as follows.

No Valid HDD!

Select HDD First!

5.1.5 Verify HDD

Now press ESC to return to Function 12, and then select part 5 Verify HDD as the following figure

shows. Verify HDD is to verify if the hard disk or any of its partitions can work well.

12-05. Adv Setup

Verify HDD

Press ENT to enter the next figure. Use ▲ ▼ to confirm Disk or Parti.

Press ENT to verify. After verification LCD will show the results as follows.

Overburn

Off

5.1.6 Burn-in

Now press ESC and ▼ to enter the following figure. Burn-in is to simulate the copying progress

many times. The time can be from 1 to 1000. After each cycle of simulation, the DVDs on the DVD

writers will eject automatically and recede for the next bout of simulation.

Verify Disk or

Paration? Disk

ARS-2057/2050/2050P Manual