User`s manual

2030T/2033/2033P/2033S/2039

Chapter 6 Troubleshooting

6.1 About LCD

After powering on if there is no LCD, check if the connection of power cord is firm

and the environment of power outlet is normal.

6.2 About Error Messages

During Copy, Test, Compare and Verify, etc. if you press ESC to abort, an error

message will appear on LCD. Abortion may cause the copy controller to hang up,

therefore you have to power on again.

If reading fails, an error message will appear on LCD. Get a new source DVD to try

again.

If the copy controller hasn’t detected any device after powering on, an error message

will appear on LCD.

If a DVD-ROM or a DVD writer cannot read, confirm the format of the source DVD

and check if it is damaged.

Use any DVD writer to read the source DVD. If it works, the DVD-ROM is probably

defective or not compatible with the source DVD.

6.3 About DVD-ROM/DVD Writers