Specifications

42
ARS-2030/2032 Copy Smart Plus
Load Default
Config? Yes
Load Default
OK
12-10. Adv Setup
Load Default
↑↓ Enter ESC
Hold ESC to exit
Test finished
12-09. Adv Setup
H/W Diagnostic
5.12.10 Load Default
This function will reset whole previous setting back to factory’s
default setting. Different settings will cause duplicator to react
differently.
Using arrow button to change setting. When
“Yes” is selected, the duplicator will return to
factory’s default setting.
Press “ENT” button to enter “Load Default” and
“ESC” to exit.
Press “ENT” button to enter “H/W Diagnostic”
and “ESC” to exit.
The LCD message will show the setting have
been changed by “OK” as left.
After the button function testing, the system will self-test SDRAM, the
hardware connecting test, and flash test. Every testing process will
be shown on the LCD. It just take a minutes to get the results of
hardware diagnotic. It is a easy way to know if the system work
properly.
LCD will ask user to do the button test. Follow-
ing the LCD instruction test each function
button.
When testing is finished, the LCD will show the
“Test finished” message. Press “ESC” button to
go back 12-09 manual.