Specifications

40
ARS-2030/2032 Copy Smart Plus
Sel burn-in num:
Run Continuous
Sel burn-in num:
Run Continuous
Burn-in
Erase&Copy
12-06. Adv Setup
Burn-in
Burn-in
Test
5.12.6 Burn-in
This function is a burn-in test function. It will run the emulate
writer function continuously. Between each cycle of emulate
write, the CD discs in CD writers will be ejected automatically
and re-insert again for continuous testing.
The data will not be writed on the blank
CD discs and the discs will remain blank
as original after test.
5.12.7 Update Firmware
This function will update your firmware to the latest one. Place
the CD disc which it contain the latest firmware data (firmware
CD disc) into CD-ROM drive, the duplicator will find the data
and update its firmware automatically. During updating, do not
turn off the power of machine since the update will not be
finished till machine reset itself.
Press “ENT” button to enter “Burn-in” and
“ESC” to exit.
Using arrow button to change
“RunContinuous”, “1~10”, “10~100”,
“100~1000” setting. Press “ENT” or “ESC”
button to go back 12-06 manual.
Using arrow button to change
“RunContinuous”, “1~10”, “10~100”,
“100~1000” setting. Press “ENT” or “ESC”
button to go back 12-06 manual.
The system will repeat to erase and write
on the CD-RW discs. It is only for CD-RW
discs to do rewriteable.