User`s manual

ARS-2030LD/2032D/2034D

Chapter 5 Troubleshooting

5.1 About LCD

After powering on if there is no LCD, check if the connection of power cord

is frim and the environment of power outlet is normal.

5.2 About Error Messages

During Copy, Test, Compare and Verify, etc. if you press ESC to abort, an error

message will appear on LCD. Abortion may cause the copy smart plus to hang up,

therefore you have to power on again.

If reading fails, an error message will appear on LCD. Please get a new source DVD

to try again.

If the copy smart plus hasn’t detected any device after powering on, an error message

will appear on LCD.

5.3 About DVD-ROM/DVD Writers

If a DVD-ROM or a DVD writer cannot read, please confirm the format of the

source DVD and check if it is damaged.

Use any DVD writer to read the source DVD. If it works, the DVD-ROM is probably

defective or not compatible with the source DVD.

Use a fine DVD writer as the data reader, and set the “Read Speed” at minimum.