User`s manual

14
ARS-2030LD/2032D/2034D
l When copying comes to an end, the passed DVDs will eject automatically.
The default is eject automatically, but you can change it.
l The failed DVDs will remain in the writers. The default is keeping failed
DVDs in the writers, but you can change it. To take the failed DVDs you
need to press the “eject” buttons on the writers.
l During operation do not press any button on your copy smart plus, because
interruption will harm the device, and DVDs will be damaged.
3.2.2 Without a HDD
If you don’t install a 3.5” hard disk to your copy smart plus, the operation procedures
will be as follows.
l Place a source DVD into DVD-ROM.
l Switch to function 1 Copy by pressing ▲ . Place blank DVD disks into the
DVD writers, and press ENT to start copying.
l When copying comes to an end, the passed DVDs will eject automatically.
The default is eject automatically, but you can change it.
l The failed DVDs will remain in the writers. The default is keeping failed
DVDs in the writers, but you can change it. To take the failed DVDs you
need to press the “eject” buttons on the writers.
A figure of ATA-66 cable layout is printed on the next page.