User`s manual

ARS-2016/2016E Manual

Before connecting an IDE hard drive to the cabinet, you have to power off the sys-

tem, then follow the two steps below to open the cabinet.

Step 1: Insert the plastic stick into the loophole to loosen the handle.

(Use a pin in case of losing the stick.)

Step 2: Hold the handle to pull out the cabinet.

Figure 4-2

NOTICE: The handle is a switch to control the hard drive power, so do

not open it arbitrarily during operation.

Follow the 5 steps to connect an IDE hard drive to the cabinet. Please do the job

according to Figure 4-3 on page 17.

Step 1: Find out pin 1 of the 40-pin connector on the IDE hard drive.

Step 2: Find out the color line of the IDE cable inside the cabinet, which indicates

pin 1 of the 40-pin connector.

Step 3: Connect the IDE cable to the IDE hard drive by pin 1 to pin 1.

Step 4: Connect the 4-pin power connector inside the cabinet to the IDE hard

drive’s 4-pin connector.

Step 5: Finally replace the cabinet.

Step 1

Step 2

loophole