User manual

4.8 NETWORK

If NETWORK is selected by ENTER button, below “NETWORK SETUP” figure will be

appeared.

1) CONNECT: STATIC or DHCP

STATIC IP or DHCP of CONNECT can be selected by LEFT or RIGHT button. Or after

pressing ENTER button, STATIC or DHCP can be selected by UP or DOWN button. And

then ENTER button is used for confirming setting value.

2) IP ADDRESS, 3) SUBNET MASK, 4) GATEWAY, 5) DNS:

If DHCP is selected, IP ADDRESS/ SUBNET/ GATEWAY/ DNS will be automatically

assigned. But If STATIC is selected, manual input for IP ADDRESS/ SUBNET/ GATEWAY/

DNS will be needed.