Operating instructions

TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 82 Version 1.3b October 2005
Includes all versions through G1-a20x
Form 10 Continued
Example
10-01-IP S.D.I.
11 13 22 00 55
In the above example an incoming DISA caller subject to Single Digit dialing group 01 who dials 1 will call station
11, dialing 2 will call station 13, 3 will call Station 22. Dialing 4 will allow the caller to dial the full extension number
of any extension, which starts with 4, e.g. 44. 55 has been assigned as a Hunt Group Pilot number so a DISA caller
dialing 5 will call the Station hunting group which has 55 as it's pilot Number. Pilot numbers are set in Mode 67 and
Hunt groups are programmed in Form 68 and 69.
A station with single digit dialing enabled will ring the station number programmed in Item 01 whenever that station
dials 1. It will ring the station number programmed in Item 02 whenever the station dials 2, etc.
Single Digit Dialing is enabled on the system by programming Form 05-04-07 as 1 (Enable).
Any station that is to utilize Single Digit Dialing must be assigned to a Single Digit Dialing Group
on Form 41-STN-01.
DISA Single Digit Dialing is enabled on Form 05-11-08. The group selected will correspond to the table entry on
this form. A setting on 05-11-08 of 0 disables DISA Single Digit Dialing.
Form 11 - Date and Time Settings:
Form 11 - Date and Time
Item 01 02 03 04 05 06
Input
01= Month 02=Date 03=Year 04=Hour 05=Minute 06=Day of Week
General:
This program permits the setting of system Date & Time.
Description:
The Date & Time will be held during a power failure on the TD-824I if G1-MSC is fitted, there is no need to reset the
Time after power is restored.
All entries are two digit, except 06 which begins with Sunday as 0, Monday as 1, Tuesday as 2, etc.