Operating instructions

TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 80 Version 1.3b October 2005
Includes all versions through G1-a20x
Form 09 Continued
i) Pause : During dial procedures, the dialing will wait for a programmable period
(Refer Program 05-01-06).
ii) Flash : This will make a loop disconnection of a pre-assigned duration.
(Refer program mode 05-02-05).
iii) Pulse to DTMF : If the dialed signal is "pulse", it will change to "DTMF".
Note: Pressing {Don’t Care} will erase the digit which the cursor is on.
Pressing [REDIAL] will erase all the assigned digits.
Note: An indication of TK:00 will cause the system to utilize the first free line in a station's dial 9 group.
An indication of 01-08 will cause the system to always select the same CO Line.
Note: To enter a name, press the CHG (Volume Down) key until the letter "N" appears in the upper right
corner of the LCD display. Letters and numbers may be entered through the keypad. For Dial by
name to operate, 05-05-05 must be enabled.
Phone numbers may not exceed 30 digits in length (including special characters). Names may be entered up to 30
characters, but will only be displayed to 16 characters.