Operating instructions

TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 68 Version 1.3b October 2005
Includes all versions through G1-a20x
05-12-06 Trunk Group Access Type:
If this parameter is set to 0 then line selection will be the first available trunk in the users dial (9-0) group. If the
parameter is set to 1 then the lines will be selected in a Circular fashion till all lines have been used and then the
selection will start again. Do NOT use Circular with CO lines unless there is a very good reason as call collision is
more likely to occur as a result.
0=Linear Hunt 1=Circular Hunt
05-12-07 - LED indication of Check in / Check out:
This parameter disables or enables the LED indication for Check in/Check out features for the DSS consoles and
DSS Keys
The LED indications are as follows:
Red and slow flash: If the Reception has checked out an extension, the LED for extension will
slow flash red.
Green: When the checked out extension’s room has been cleaned by the
cleaner(maid), they can dial [776] from the phone and hang up. The LED for
that extension will go Green. This means the room is ready for a new guest
Red: The room is checked in and the phone is in use.
Off: The room is checked in and idle.
0 = Disable 1= Enable
05-12-08 – Reserved: