Operating instructions
TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 58 Version 1.3b October 2005
Includes all versions through G1-a20x
05-07- 04 - DISA Operator Recall Capability (No Digits Dialed):
Setting Situation
No dialing after the first
voice announcement
from the VSU.
The VSU has
announced that the
called station is busy
or no answer
The VSU has already
announced the invalid number
or a dialed number that has not
been received completely.
0=
*
*
*
1=
T
*
*
2=
*
T
*
3=
T
T
*
4=
*
*
T
5=
T
*
T
6=
*
T
T
7=
T
T
T
Note
“*” = Transfer the incoming
call to console
“T”=System will announce
VSU function 06 (if
programmed) to the
incoming call if no digits
dialed timer has expired.
System releases call (hangs
up).
“*”=See Form 46-ST-04
“T”=See Form 46-ST-04.
If 46-ST-04 is no recall to
operator, VSU function 06
will be played to the caller
(if programmed). System
will release call (hang up).
“*”= System will transfer incoming
caller to system operator if 05-08-07
has expired.
“T”=System will play VSU function 06
(if programmed) to the caller if 05-08-
07 has expired. System will release
the call (hang up).
05-07-05 - DK Calling Proof
If the setting is enabled, then no audio will be sent from the handset until 3 digits are received by the
KSU from the key station dial pad. The intent of this option is to prevent the use of external dialing
devices in order to bypass existing toll restrictions. This parameter will be automatically disabled on
any lines which are set to Pulse dial.
0=Disable 1=Enable
05-07-06 - SMDR Dialed Number Print
If setting is "0", then the full length of the telephone number will be output
to the SMDR. If setting is n, then the length of the telephone number will
be n digits long.
0=Print All Digits
1=Print 1st digit 2=Print First 2 digits 3=Print First 3 digits
4=Print First 4 digits 5=Print First 5 digits 6=Print First 6 digits
7=Print First 7 digits 8=Print First 8 digits 9=Print First 9 digits
05-07-07 CO Trunk Guard Timer
This parameter is used to insert a pause between a line being
released and being able to be re-selected for outward dialing.
0=No delay
1=1 second 2=2 seconds 3=3 seconds
4=4 seconds 5=5 seconds 6=6 seconds
7=7 seconds 8=8 seconds 9=9 seconds
05-07-08 - Reserved