Operating instructions

TransTel Model TD-824-I Digital Telephone System – Programming Forms Manual
Page 57
Form 05-07 - System Parameters Form - Timer/Codes
G1-a20u
Form 05-07- 01 02 03 04 05 06 07 08
Item
Range of Entries 0 - 1 0 - 1 0 0 - 1 0 - 7 0 - 9 0 0
Default 0 0 0 0 0 0 0 0
05-07-01 - Intercom Step Call:
If setting is enable, when calling an internal station which is busy or does not answer, pressing [4] will
call the station on the next port which is in the same station group as the called station. If setting is
disable then there will be no transfer.
0=Disable 1=Enable on Busy
2=Enable on No Answer 3=Enable on Busy and No Answer
05-07-02 - SLT Calling Proof:
In areas where dial tone from the CO is delayed, this option will disallow dialing before dial tone is
available. If dial tone is delayed, SLT users may attempt to bypass toll control by dialing a DTMF
digit before dial tone is available. Enabling this option causes toll checking to not occur until dial tone
is heard on the CO trunk. If digits are dialed before dial tone is available, they are disregarded by the
TD-824i.
0=Disable 1=Enable
05-07-03 – Splash Tone On Page:
G1-a20u
This option enables or disables the splash tone that is heard at the beginning of a page. Please
note, this option only affects key telephones. Single line sets will always cause a splash tone prior to
paging. Default is 0 = enabled
0= Splash Tone Enabled 1=Splash tone Disabled