Operating instructions

TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 52 Version 1.3b October 2005
Includes all versions through G1-a20x
05-04-06 - Speed Dial Distribution:
This parameter sets the number of speed dial numbers allocated to the system speed dial. Adding
extra numbers to system Speed Dial reduces the number of personal Speed Dial numbers available
to share between individual stations
Numbers after backslash indicate sets available with name feature enabled.
System Personal System Personal
0 100 Sets 500/200 Sets 3 400/300 Sets 200/000 Sets
1 200 Sets 400/100 Sets 4 500/300 Sets 100/000 Sets
2 300 Sets 300/000 Sets
05-04-07 - Intercom Single Digit Dialing:
Single digit intercom allows the stations to call up to 5 other stations by dialing one digit only (1 to 5).
This feature is for the Hotel / Motel Environment. Up to eight different groups may be programmed. If
a group is not programmed with any entries then stations which are in the same number station
group will be able to make intercom calls without dialing the room to room dialing prefix (6).
0=Disabled 1=Enabled
05-04-08 - Message Waiting (MW) Status for Single Line Phones:
G1-a20u
If the setting is Ring, the single line phone will receive 30 seconds intercom ringing every 5 minutes
until the station answers.
If the setting is Voice Message, the station which is left a message will hear the voice message which
is stored by the console after answering the message waiting.
If the setting is 250 ms. ring the analogue phone will receive two 250 ms. ring burst every 5 minutes.
This is for use with the special telephones to turn on message lamp.
0= 90V Message Waiting Lamp
G1-a20u
1=MW Ring - Route recipient to message originator.
(Day and Night)
2=MW - Route to VSU. (Day and Night)
3=250 millisecond ring every 5 minutes. (Day and
Night)
4=No MW during Night Service