Operating instructions
TransTel Model TD-824-I Digital Telephone System – Programming Forms Manual
Page 51
Form 05-04 - System Parameters Form - Codes-2
G1-a20u
Form 05-04- 01 02 03 04 05 06 07 08
Item
Range of Entries 0 0 - 1 0 - 2
5 - 7
0 - 1 0 0 - 4 0 - 1 1 - 2
Default 1 1 0 0 0 1 0 1
05-04-01 – RS-232 Baud rate:
This paramter controls the output speed of data from the system.
0=1200bps 1=2400bps 2=3600bps 3=4800bps
4=9600bps 5=19200bps 6=38400bps 7,8,9=56000bps
05-04-02 - Dial 9 (Hybrid) Activation Turns on Dial 9 (pooled CO lines):
This parameter sets if a station can access an outgoing line by dialing 9. If this parameter is disabled
the station can still access an outgoing line by pressing a line key
0=Dial 9 access Disabled 1=Dial 9 access Enable
05-04-04 - Time Format Display:
0=12 Hour Clock (AM/PM) 1=24 Hour Clock 00:00-23:59
05-04-05- SLT Ignore Flash Timer:
This parameter is used for certain single line telephones that need to be “debounced” when the
station goes off hook. When a station goes off hook, the system will ignore any flash from the
telephone until this timer expires. This option generally will not be used in North America.
0=No delay 1=1 second delay 2=2 second delay 3=3 second delay 4=4 second delay
5=5 second delay 6=6 second delay 7=7second delay 8=8second delay 9=9second delay
05-04-03 – Call Limit Type:
This parameter decides what action will be taken if a station has limit call duration enabled in Mode
40-nnnn-03. Settings 0 to 3 are for outgoing calls only. The outside party will also hear the warning
tone.
0=Continuous Warning After Timeout (Outgoing).
1=1 Second Warning at Duration Limit (Outgoing).
2=1 Second Tone 10 seconds Prior to Timeout. Continuous Tone 5 seconds prior.
Line is released at Timeout (Outgoing).
3 =1 Second Tone 60 seconds Prior to Timeout. Continuous Tone 30 seconds prior.
4= immediate disconnect
G1-a10an
5=Same as 0 above, except affects both Incoming and Outgoing.
6=Same as 1 above, except affects both Incoming and Outgoing.
8=Same as 3 above, except affects both Incoming and Outgoing.
7=Same as 2 above, except affects both Incoming and Outgoing.