Operating instructions

TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 38 Version 1.3b October 2005
Includes all versions through G1-a20x
Series Model TD-824i - Programming Forms Manual
Programming Information
This document contains the system forms required to program the TD-824i and an explanation of the parameters.
New Systems
We recommend that all new systems have the system memory reset before system programming takes place.
This ensures that any extraneous information that may be present in system memory is erased and that the system
database will not be corrupt.
To Reset System Memory.
Enter System Programming :
From an LCD equipped Superkey DK Telephone Set:
1. Press [PROG]. Press [2].
2. Enter Password if programmed. (New systems will not have a system password).
3. Press [SAVE].
4. LCD display will show:
PROGRAM MODE: __
(01 - 93)
5. Enter [2][5]. Press [SAVE]. Display will show:
25- Reset Data
0-9 Default
6. Enter [2].
7. System Database is now reset. LCD will display:
PROGRAM MODE: __
(01 - 93)
8. You may commence database entry at this point, or exit system programming by pressing SPK key
or by lifting and replacing the handset.
To Enter System Programming:
1. Press [PROG]. Press [2].
2. Enter Password if programmed. (New systems will not have a system password).
3. Press [SAVE].
4. LCD display will show:
PROGRAM MODE: __
(01 - 93)
5. You may begin system programming at this point.
Lost Programming Key
If programming personnel accidentally delete or change the programming key (07-gp-29=FN:01), you can enter
programming from DK1-D, DK-2, or a DK-3 set connected to the first port (11) of the system. To enter
programming when the key has been removed:
1. Press [SPK].
2. Dial [7] [0] [2].
3. Press [SAVE]. You will be in system programming (only if password has not been set).
4. Immediately go to Form 07-01-29 and program the key to be FN:01 to restore your programming
capabilities.