Operating instructions

TransTel Model TD-824-I Digital Telephone System – Key Telephone Operation Manual
Page 177
Dial the station number where the call needs to go.
Wait for the station to answer.
Press TRF/FL or hang up (depending on programming).
The call has been successfully transferred.
If you have a DSS button for the station where you transfer the call, you do not need to press the HOLD button first.
Just press the DSS button for the station where you want to transfer the call. Then you use either the Unscreened
or Screened method of transfer.
Call Waiting (Camp On)
If the station you call is busy, you can “mark” the station so that when the station becomes free, the called station
will ring back to your telephone.
When you hear busy tone, Press MSG key.
Hang up.
When the other station is free, your station will ring with a special ringing tone. When you answer, the other station
will begin ringing.
Check In – Check Out (Operator Function)
Check In - Check Out allow an operator station to change the dialing restriction of a telephone. This is commonly
used in Hotel applications where there is a need to “turn off” dialing capabilies of individual room telephones. This
function is only available to system operators.
Note: The use of Check In - Check Out requires that function keys are programmed on the telephone set.
Check In:
1. Press [Hotel] and the digit 1.
2. Dial the extension number to be unrestricted.
3. Press [SAVE].
4. Press [SPK] to return the set to idle.
Check Out:
1. Press [Hotel] and the digit 2.
2. Dial the extension number to be restricted.
3. Press [SAVE].
4. Press [SPK] to return the set to idle.
Conference
You can conference any two parties, internal or outside CO lines.
Establish your conversation with the first party.
Press HOLD to hold the first party.
Get the second party on the line.
Press DND/CN when you have the second party on the line.
You know have a three way conference.
You may continue this procedure to add additional parties to the conference.
You can leave the conference and allow the other two parties to continue the conversation. Just press the
DND/CN key before you hang up. If you don’t press the key and just hang up, the other parties will be
disconnected, if they are both outside lines.
To rejoin the conference, press either CO line button and then the DND/CN key.
If you cannot rejoin an unsupervised conference, you may not have the capability in your class of service. Check
with your system administrator or check system programming to see if your override capability is enabled.