Operating instructions

TransTel Model TD-824-I Digital Telephone System – Programming Forms Manual
Page 145
Form 78 - continued
Description:
Form 78-ext-01 - Least Cost Routing Access Level:
This parameter assigns the LCR routing level for each station.
0 = Disable LCR
1 = Allow this station to use the 1
st
priority trunk group
only
2 = Allow this station to use the 1
st
and the 2
nd
priority
trunk groups only
3 = Allow this station to use the 1
st
~3
rd
priority trunk
groups only
4 = Allow this station to use the 1
st
~4
th
priority trunk
groups
5 = Allow this station to use the 1
st
~4
th
priority trunk
groups. If there is not any available trunk in the 1
st
~4
th
priority trunk groups, system will allow this station to
use the normal assigned dial 9 group.
Form 78-ext-02 - LCR - Direct Access a Trunk:
This parameter allows a station to select a trunk directly under LCR environment.
If you wish to force users to use LCR, this option must be set to 0 (disable direct trunk access).
0 = Do not allow to access a trunk directly (need to dial 9 (or 0) first).
1 = Allow this station to access a trunk directly (by pressing line key button).
Form 78-ext-03 - 1A2 Emulation (Station Programming):
When extension talks with a trunk, the other extension can make a conference by pressing this Trunk's button if
the 1A2 Emulation is allowed.
0 = No Access 1 = Access with tone notification 2 = Access without tone notification
1A2 Emulation status is setting below:
29-Tk-06 78-St-03 Status
0 N/A No access
1 0 No access
1 1 access with tone
1 2 access with no tone
Even if 1A2 Emulation status is programmed, an extension can temporarily disable it by pressing the Function key:
[1A2 Emulation Privacy] – (FN:24 for DSS key in mode 07). When an extension sets 1A2 Emulation Privacy, the
key LED will light, and other extensions will not be able to access the line in use. When the extension presses [1A2-
Emulation Privacy] again 1A2 Emulation Privacy is cancelled and the LED will extinguish.
Form 78-ext-04 - Call Forward Busy to a Pre-assigned Hunting Group (Keysets and Single Line Sets):
This parameter allows Call forward busy to the pre-assigned hunting group. This parameter will not be disabled
if the user enables or disables the “Personal Call Forward” function, but will be temporarily overridden. If the
user has set the Personal Call Forward to some specified number, system will use “Personal Call Forward”
rule first. When the user disables Personal Call Forward, this option will once again go into effect.
0=Disable 1-9=Forward to Hunt Group 1-9
Form 78-ext-05 – Reserved: