Operating instructions

TransTel Model TD-824-I Digital Telephone System - General Description - Installation - Programming Forms Manual
Page 126 Version 1.3b October 2005
Includes all versions through G1-a20x
Form 54 - Exception (Allow) Tables: Form 64 - Deny Tables:
Entry
Number
Actual Entry (Up to 12 digits in Length)
Entry
Number
Actual Entry (Up to 12 digits in Length)
01 01
02 02
03 03
04 04
05 05
06 06
07 07
08 08
09 09
10 10
11 11
12 12
13 13
14 14
15 15
16 16
Form 54 Notes
Entries on Form 54 provide exception (allowances) to a condition that is restricted on Form 64.
In default any station allocated to Toll Plan 4 will be able to dial unrestricted until the associated forms are
programmed.
Valid entries in this form are 0 to 9, d and _.
d = Don't care and means that any digit can be dialed in this position. _
= No digit is allowed to be dialed beyond this position.
If a digit is allowed as the beginning of a number then the entry should be filled with don't care's to the end of the
line or the caller will not be able to dial the full number.
Form 64 Notes
Entries on this form provide dialing restrictions to a telephone subject to this toll plan. If an entry is not followed by
a “d”=don’t care digit. The system will not consult the corresponding exception (allow) table, Form 54. The call will
be restricted. An entry of “624" will cause a call beginning with the digits 624 to be disconnected.
If an entry is followed by a “d” digit, the system will check the exception (allow) table, Form 54 to see if a valid
exception exists.
An entry of “1d” will cause the system to check Form 54 for an exception of 1+additional digits. If an exception is
found on Form 54, the call will be allowed. If an exception is not found, the call will be restricted.
An entry of 1d on Form 64 will check Form 54 for any exceptions. If 1800dddddddd is found, all 1+ dialing will be
denied, except for 1-800 calls.