Operating instructions

TransTel Model TD-824-I Digital Telephone System – Programming Forms Manual
Page 117
Form 46 continued
46-ext-01 - Dial 87 Line Group:
If this setting is from 1 to 8, after the station dials [87], the system will automatically search for a free line which is
assigned in group 1 to 8 in Program Form 38.
0=Disabled 1-8=Group Number
46-ext-02 - Message Waiting Level:
The Stations assigned higher levels can leave message for stations with the same or lower levels. Ten levels (0-
9) are available (9=highest level, 0=lowest level cannot leave messages).
0=Cannot leave messages
1-9 -Able To leave messages for stations of equal or lesser Message Waiting Level
46-ext-03 - Automatic Answer Capability (Digital Telephone Sets):
This parameter if enabled will automatically switch on the microphone of the station if it receives an intercom call.
This setting is independent of whether the system is set to voice or ring signaling for intercom calls.
0 = No 1 = MIC permanently on
2 = MIC will switch on for Intercom calls
46-ext-03 – Caller ID to Single Line stations (Connected to TD-SLC1 card):
This enables system to send different internal CLIP(Caller ID) signals to the single line telephone
0 = Disable Caller ID
1 = Enable to send SDMF(number without name)
Caller ID to the single line telephone
2 = Enable to send MDMF(number with name) Caller
ID to the single line telephone
46-ext-04 - DISA Recall Capability To Operator (No Answer/Busy):
If this parameter is enabled then when a DISA call rings an extension but the station is busy or does not answer
(depending on setting) after the voice message announcing the status of the station is heard, the system will
recall the operator after the assigned DISA transfer time. Using settings 1 to 3 the called station will continue to
ring until the console answers the call. Using Settings 5 to 7 the call will ring the station for 1 cycle (Form 05-08-
06) and then camp on to the console only and cease to ring the called station. If the parameter is set to 0 then
the call will stay at the station until answered or terminated.
0=No Recall to Operator 1=Recall on No Answer
2=Recall on Busy 3= Recall on Busy and No Answer
5=Recall on No Answer (Forwarding station stops
ringing)
6=Recall on Busy and Stop Busy Remind Tone at
Forwarding Station
7= Recall to Operator on No Answer/Busy (Stop Notification at Forwarding Station)