Operating instructions

TransTel Model TD-824-I Digital Telephone System – Programming Forms Manual
Page 115
Form 45 Continued
45-ext-01 - Intercom Dialing Restriction:
If this setting is enabled, the station can not make an intercom call by dialing a station number. Under this
condition, the Key Phone still can press a Flexible Key to make an intercom call or the Key Station or Analogue
phones can call a station using the "Single Digit" feature.
0=Disable 1=Enable
45-ext-02 – Reserved:
45-ext-03 – Reserved:
45-ext-04-Trunk Access:
If this function is disabled then the station will be unable to access any trunks for incoming or outgoing calls.
0= Enabled - Trunk Access Allowed 1=Disabled - Trunk Access Disallowed
45-ext-05-Inter-Station Group Calling:
If this function is disabled then stations will not be able to make intercom calls outside their own station group
(Form 41-st-01). This parameter is for use in tenant arrangements where each company wishes to remain totally
separate although some stations can still be allowed this function, for instance a shared Receptionist.
0=Enable 1=Disable
45-ext-06. Receive Break Alarm:
If this parameter is disabled then the station will not receive the Break Alarm signal if one has been programmed
in Form 39.
0 = Enabled – Receive Alarm 1 = Disable – Do not Receive Alarm
45-ext-07 - System Speed Dial Access:
If this parameter is disabled then the station will not be able to access any of the Speed Dial numbers which have
been unrestricted in Mode 05-05-03/04 if they conflict with the stations toll restrictions
0= Enabled – Toll Control is bypassed for unrestricted
numbers
1=Disabled - Toll Control applies to unrestricted
stations.
45-ext-08 - Record Station's SMDR Data:
If this parameter is disabled then calls to and from this station will not recorded or output to the SMDR or the Mini
Accounting feature. When the Mini Accounting feature is enabled (see Mode 14-01-08) then all stations which
are used for administration should have this feature disabled to prevent using memory unnecessarily to record
their calls. If calls are allowed to accumulate against stations which are not checked in or out regularly then the
system memory buffer will become full and calls will not be recorded.
0 = Record 1 = Do not Record