Installation guide

Using a Standby Acano Server
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 90
5. Enter the following command and confirm to restore from the backup file:
backup rollback <name>.
This overwrites the existing configuration and reboots the Acano solution. Therefore a
warning message is displayed. The confirmation is case sensitive and you must press upper
case Y, otherwise the operation will be aborted.
Note: It is not possible to create a backup from one type of deployment (Acano Server or
virtualized) and roll it back on the other type.
A successful operation returns:
When you restore from the backup, everything is overwritten including the IP address,
certificates and the license.dat file. Therefore if you are restoring onto a different server from
the one that the backup was made on, you must manually copy the original license.dat file
and any certificates that are not valid on the new server. Note that the license.dat file is tied
to the MAC address of the server; therefore after the backup has been restored to the new
server, the license from one server will be invalid on another one.
6. Establish an SFTP connection with the standby server
7. Upload the previously saved original license.dat file back on to this server
8. If necessary:
a. Put back any certificates and private keys (if the restored versions are not valid on the
standby server).