Installation guide

Configuring a Polycom DMA for the Acano solution
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 84
Appendix I Configuring a Polycom DMA for the
Acano solution
For calls from a Polycom DMA environment to the Acano solution, create an External SIP Peer
on the Polycom DMA that will point to the Acano solution, and then configure a Dial Rule on the
Polycom DMA that will direct calls to it.
To configure the Acano solution for the Polycom DMA, follow the instructions in the body of this
document to set up a dial plan rule that points to the Polycom DMA server in the Web Admin
Interface Configuration > Outbound Calls page. Also ensure that the correct ports are open
(Incoming/Outgoing UDP 32768-65535 – RTP).
Setting up the External SIP Peer
On the Polycom DMA:
1. Go to Network > External SIP Peer > Add (see right)
2. In the External SIP Peer page configure the following (see below):
a. Name: Acano
b. Description: a meaningful phrase, possibly Acano IP Peer
c. Next hop Address: IP Address of Acano Call Bridge
d. Port: 5060
e. User Route Header: selected
f. Type: Other
g. Transport Type: TCP