Installation guide

Example of Configuring a SIP Trunk to CUCM
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 77
 Device pool = The pool you want your device to belong to (as configured in System >
Device Pool in CUCM)
 SRTP Allowed = Select if you want media encryption (we only do media encryption if the
trunk is TLS)
 Outbound Calls > Calling Party Transformation CSS = Select as appropriate
 Sip Information > Destination Address = The destination address e.g.
acanoserver.example.com or an IP address.
 Sip Information > Destination Port = 5060 for TCP or 5061 for TLS
 SIP Trunk Security Profile = As in Step 2: Creating a Security profile above. (Either the
security profile that you created or "Non Secure SIP Trunk" if this trunk will be a TCP.)
 SIP Profile = As in Step 3: Creating a SIP profile above.
 Normalization Script = "vcs-interop" if available. (Only necessary if SRTP will be used.
Even if you do not have a VCS, the Acano solution has the same interop issues that
VCS would have, and therefore this script is suitable for a trunk to the Acano Core also.)
5. Click Save.
Step 5: Configuring the dial plan for outbound calls
This step depends on your needs; for example, you can create a Route Pattern in order to route
specific numbers to the SIP trunk. Equally, you can configure a SIP Route Pattern on CUCM in
order to route calls to the SIP trunk e.g. route @example.com calls to the SIP trunk.
Step 6: Testing
Make some test calls.