Installation guide

Example of Configuring a SIP Trunk to CUCM
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 76
5. Enter the Certificate Name as CallManager-trust and type in a Description.
6. Click Choose File to find your certificate. This can be the root certificate or the Acano
Server’s certificate.
7. Click Upload File.
Step 2: Creating a security profile
If the trunk will be TCP, then use CUCM’s default security profile called Non Secure SIP Trunk
when you create the SIP Trunk. To use TLS, or something other than the standard security
profile, follow these steps:
1. Go to Cisco Unified CM Administration and log in again.
2. Go to System > Security > SIP Trunk Security Profile and click Add New.
3. Complete the fields as follows:
 Name = Type in a name e.g. "Acano Server Encrypted TLS SIP trunk"
 Device Security Mode = Encrypted
 Incoming Transport Type = TLS
 Outgoing Transport Type = TLS
 X.509 Subject Name: The X509 subject name of the certificate installed on the Acano
Call Bridge (usually the FQDN of the Acano Server)
 Incoming Port: 5061
4. Click Save.
Step 3: Creating a SIP profile
CUCM comes with a profile called Standard SIP Profile For TelePresence Conferencing
1. In Cisco Unified CM Administration, go to Device > Device Settings > SIP Profile and click
Add New.
2. Configure the fields as appropriate.
3. Click Save.
Step 4: Creating a SIP trunk
1. In Cisco Unified CM Administration, go to Device >Trunk and click Add New.
2. Configure these fields:
 Trunk Type = SIP trunk
 Device Protocol = SIP
 Trunk Service Type = None(Default)
3. Click Next.
4. As a minimum, complete these fields:
 Device name = Type in a name e.g. Acanoserver (no spaces allowed)