Installation guide

Example of Configuring a Static Route from a Lync Front End Server
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 72
Enable-CsTopology
This command enables the new topology. Users may have to logout and login again to
update to the new HD720p setting, all other settings are automatic and should work within a
few minutes.
Acano Solution Configuration
1. In the Web Admin Interface go to Configuration > Outbound Calls
2. In the blank row, for Domain, enter the Lync domain that will be matched for calls that need
to be sent to Lync
3. For SIP Proxy to Use, do one of the following:
 Leave this field blank and the server will perform a DNS SRV lookup for the called
domain using _sip._tls.<yourlyncdomain>.com
 Enter the Front End Pool and the server will perform a DNS SRV lookup for that defined
domain using _sip._tls.<yourlyncdomain>.com
 Enter the Front End Pool and the server will perform a DNS A record lookup for the Host
entered if the above SRV lookup fails to resolve
 Enter the IP address of your Lync Front End server
4. For Local Contact Domain, enter the domain that you route to your Acano solution, e.g.
acano.yourcompany.com.
5. For Local From Domain, enter the domain that you want the call to be seen as coming from.
Note: If you leave Local From Domain blank, the domain used defaults to the Local Contact
Domain.
6. For Trunk Type, select Lync.
7. Select Add New.
After completion you should be able to call from the Lync environment to the Acano solution and
from the Acano solution to Lync.