Installation guide

OpenSSL Commands for Generating Certificates
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 66
iii. After entering the command, a CA selection list is displayed similar to that below.
Select the correct CA and select OK
iv. Do one of the following:
 If your Windows account has permissions to issue certificates, you are prompted to
save the resulting certificate, for example as cacert.pem. Go on to the step 4 below.
 If you do not see a prompt to issue the resulting certificate, but instead see a
message on the command prompt window that the 'Certificate request is pending:
taken under submission', then follow step 2d in Appendix D before going on to step
4 below.
4. Transfer both this file and the private key to the MMP using SFTP.
CAUTION: If you are using a CA with the Web Enrolment feature installed, you may copy the
CSR text including the BEGIN CERTIFICATE REQUEST and END CERTIFICATE REQUEST
lines to submit. After the certificate has been issued, copy only the certificate and not the
Certificate Chain. Be sure to include all text including the BEGIN CERTIFICATE and END
CERTIFICATE lines and paste into a text file. Then save the file as your certificate with a .pem,
.cer or .crt extension.