Installation guide

Web Admin Interface Settings for the TURN Server
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 57
10.2 TURN Server Settings
Follow the steps in order.
1. Ensure that you have configured the TURN server.
2. Log in to the Web Admin Interface and configure the Acano solution as follows:
 Go to Configuration > General.
 Set the following:
 TURN Server Address (Server) = internal server IP address that the Call Bridge will
use to access the TURN server to avoid firewall traversal for internal call control
 TURN Server Address (Clients) = public IP address assigned to the TURN server
that external clients will use to access the TURN server. This will be the IP address
entered in section 4.9 when you configured the TURN server.
Notes:
 For example if the interface of the TURN Server is on IP address XX.XX.XX.XX
and NAT'ed to an external IP address YY.YY.YY.YY then enter XX.XX.XX.XX
as the TURN Server Address (Server) and YY.YY.YY.YY as TURN Server
Address (Client). If the interface is on the external IP then no need to enter a
client address
 You can enter a DNS name instead of an IP address in both fields, if the DNS
name resolves to the appropriate IP address
 If you are using a public IP address, leave TURN Server Address (Clients)
address blank and set TURN Server Address (Server) to the public IP address
or DNS name used
 If you are using a two Acano Server deployment or a split virtual deployment
use the IP address of the Edge server/virtualized server for the TURN Server
Address (Server). See section 2.11 for more details of these deployments.
 Username and Password = your information