Installation guide

Web Admin Interface Settings for XMPP
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 50
8.2 XMPP Settings
1. Ensure that you have installed a security certificate for the XMPP server – see section 3.4.
2. Ensure that you have configured the XMPP server – see section 4.7
3. Ensure that you have uploaded the license key file – see section 4.7
4. Log in to the Web Admin Interface and configure the XMPP server settings as follows:
a. Go to Configuration > General.
b. Set the following in the XMPP Server Settings section, (where example.com is replaced
with your domain):
 Component Name = sf_component.example.com
 Server Address = localhost
Note: If you are using a two Acano Server deployment or a split virtual deployment
use the IP address of the Edge server/virtualized server. See section 2.11 for more
details of these deployments.
 Server Port = 5223
 Shared Secret = the component secret used in section 4.7
 Pubsub Server Address = pubsub.example.com
 Authentication Proxy Component = authp.example.com
 Authentication Suffix = * (star)
c. Select Submit at the bottom of this page.