Installation guide

Dial Plan Configuration – SIP Endpoints
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 32
5.2.2 VCS search rule configuration
Add a search rule on the VCS to route calls to the Acano solution by following the steps below
(e.g. to route any video endpoint call to a call on the Acano solution using the call prefix 88).
1. Go to VCS Configuration > Dial Plan > Search rules.
2. Give the rule a suitable name, e.g. VC EPs to Acano.
3. Set the following:
 Source = Any
 Request Must Be Authenticated = No
 Mode = Alias pattern match
 Pattern Type = Regex
 Pattern String = .*@acano.example.com
 Pattern Behavior = Leave
 On Successful Match = Stop
 Target = the zone you created for the Acano solution.
5.2.3 Creating a coSpace on the Acano solution
Create a coSpace on the Acano solution for endpoints to dial into by following the steps below.
1. Sign in to the Web Admin Interface.
2. Go to Configuration > CoSpaces.
3. Add a coSpace with:
 Name e.g. Call 001
 URI e.g. 88001
Note: coSpaces can also be created from the API. See the API Reference guide.
5.2.4 Adding a dial plan rule on the Acano solution
1. Still in the Web Admin Interface, go to Configuration > Outbound Calls and add a dial plan
rule with the following details:
 Domain = vc.example.com
 SIP Proxy = the IP address of your VCS
 Local Contact Domain = example.com
 Trunk Type=Standard SIP.
SIP video endpoints can now dial into a call 88001 hosted on the Acano solution by dialing
[e-mail].