Installation guide

Dial Plan Configuration – SIP Endpoints
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 31
5.2 SIP Endpoints Dialing a Call on the Acano Solution
As a starting point, consider using only SIP video endpoints and the configuration on the VCS
and Acano solution to direct and host calls for these endpoints.
Figure 6: Example of SIP video endpoints calling into an Acano Server hosted calls
5.2.1 SIP call control configuration
This example assumes the SIP Call Control is a Cisco VCS but similar steps are required on
other Call Control devices.
Set up a zone to route calls to the Acano solution by logging into the VCS as an administrator
and following the steps below.
1. Go to VCS Configuration > Zones > New.
2. Create the zone with the following:
 H.323 Mode = Off.
 SIP Mode = On
 SIP Port = 5060 (5061 if using TLS)
 SIP Transport = TCP or TLS, as appropriate
 SIP Accept Proxied Registrations = Allow
 Authentication Policy = Treat as authenticated
 SIP Authentication Trust Mode = Off
 Peer 1 Address = the IP address of the Call Bridge