Installation guide

Configuring the MMP
Acano solution: Deployment Guide R1.2 76-1006-06-K
Page 23
(You can use a Windows PC application such as WinSCP instead.)
4. Then to complete the upgrade, connect via SSH to into the MMP and type:
upgrade
Allow 10 minutes for the solution to restart.
5. To verify that the upgrade was successful, SSH into the MMP, log in and type:
version
4.3 Configuring the Web Admin Interface for HTTPS Access
If you have previously followed the appropriate Installation Guide you will have configured the
Web Admin Interface. If you have not configured this interface refer to the appropriate
Installation Guide for your type of deployment and do so now.
Note: Be sure to use the same names as the certificates you uploaded previously.
Note: If you configured the Web Admin Interface on the same interface as the Web Bridge,
set the default TCP port to a non-standard port such as 445 to allow the Web Bridge to
function on TCP port 443.
1. To test that you can access the Web Admin Interface, type the following into your web
browser: https:\\acanoserver.example.com.
a. If all works well proceed to next section.
b. If you cannot reach the Web Admin Interface try the following to troubleshoot the
problem as follows:
Type the following at the MMP and look at the output:
webadmin
i. The last line of the output should say "webadmin running". If it does not there is a
configuration problem with your Web Admin Interface. Check that you have enabled
it using:
webadmin enable
ii. Check that it is listening on the correct interface, i.e. admin and 443
iii. The output of that command should also tell you the names of the certificates you
have installed, e.g. server.key and server.crt.
Assuming these are the names then type:
pki match server.key server.crt
This will check that the key and certificate match.
iv. If you are still experiencing issues, contact [e-mail].
4.4 Configuring the Call Bridge Listening Interface
The command callbridge listen <interface> allows you to configure a listening
interface (chosen from A, B, C or D). If no interface is entered, the Call Bridge listens on no
interfaces. A full list of commands is in the MMP Command Reference Guide: