Datasheet

Acano X Series Server and Virtualized Deployments
Acano Solution R1.6: Support FAQs 76-1022-08-K
Page 10
4. Set up your new admin account using the following command.
user add admin admin
5. You will then be prompted for a password which you will have to enter twice.
6. Close the hatch and push the screws down to secure the hatch, no screwdriver is needed.
Note: When you log in subsequently, either via the Console port or Admin interface, using the
admin account you will be asked for this password.
What’s the difference between the MMP and application interfaces?
There are two layers to the Acano solution: a Platform and an Application.
 The Platform is configured through the Mainboard Management Processor (MMP). The
MMP is used for low level bootstrapping and configuration. It presents a command line
interface
Note: On the Acano X series servers the MMP can be accessed via the serial Console port
or using SSH on the Ethernet interface labeled Admin. In the virtualized deployment the
MMP is accessed on virtual interface A.
 The Application runs on this managed platform with configuration interfaces of its own. The
application level administration (call and media management) is done either via the Call
Bridge’s Web Admin Interface (which can be configured to run on any one of the Ethernet
interfaces) or via the API
On the Acano X series servers there are five physical Ethernet interfaces labeled Admin, A,
B C and D. In the virtualized deployment one Ethernet interface (A) is created but up to
three more can be added (B, C and D).
Note: There is no physical separation between the media interfaces A-D on an X series
server but the Admin interface is physically separate. Each interface is configured
independently of the others at the IP level. IP forwarding is not enabled in either the Admin
or host IP stack.
I cannot reach the web interface, what should I check?
Check the following:
1. Check that the certificates have been copied ok.
When you SFTP into the file system of the server do you see the certificates listed with the
other files?
Note: if you are using a Windows PC we recommend WinSCP
2. Check the certificates.
a. Double check that each certificate has created correctly, and uploaded along with the
matching key.
b. Both the certificate and the key file need to be in PEM or DER format.