Installation guide

Introduction
Acano solution: Single combined Acano server Deployment Guide R1.6 76-1054-01-H
Page 6
Figure 2: Installation and deployment documentation
1.1.1 Commands
In this document, commands are shown in black and must be entered as given—replacing any
parameters in <> brackets with your appropriate values. Examples are shown in blue and must
be adapted to your deployment.
1.1.2 Management and network interfaces
There are two layers to the Acano solution: a Platform and an Application.
 The Platform is configured through the Mainboard Management Processor (MMP). The
MMP is used for low level bootstrapping and configuration. It presents a command line
interface.
Note: On the Acano X series servers the MMP can be accessed via the serial Console port
or using SSH on the Ethernet interface labeled Admin. In the virtualized deployment the
MMP is accessed on virtual interface A.
 The Application runs on this managed platform with configuration interfaces of its own. The
application level administration (call and media management) is done via the Call Bridge’s
Web Admin Interface which can be configured to run on any one of the Ethernet interfaces.
On the Acano X series servers there are five physical Ethernet interfaces labeled Admin, A,
B C and D. In the virtualized deployment one Ethernet interface (A) is created but up to
three more can be added (B, C and D).